If you looking for preamplifier car audio then you are right place. We are searching for the best preamplifier car audio on the market and analyze these products to provide you the best choice.
Best preamplifier car audio
1. Amazon Music
2. BOSS Audio Systems AVA1210 7 Band Pre-Amp Car Equalizer with Gold-Plated Front Rear and Subwoofer Outputs
Feature
Front Adjustable EQ Band Frequencies: 125 Hz, 500 Hz, 3.5 kHz, 12 kHzRear Adjustable EQ Bands Frequencies: 50 Hz, 600 Hz, 6.3 kHz
Switchable Subwoofer Filter 32 Hz - 128 Hz, Frequency Response 10 Hz - 15 kHz
Inputs: Dual 2 Channel Source. Outputs: Front, Rear & Sub. Fader Control
Gain + / - 18 dB, Maximum Input Voltage 15 Volts, Maximum Output Voltage 8 Volts
Signal to Noise Ratio > 110 dB, Channel Separation 20 dB, Total Harmonic Distortion 0.050
Dimensions: Depth 4.6" x Width 7" x Height 1"
1 Year Warranty
7 Bands
RCA Input; Subwoofer output
Subwoofer level control; Preamp/amplified, Preamp
Night illumination
Subwoofer Level Control
Description
Front panel controls
View larger
View larger
Installation
View larger
View larger
Installation
Set your source volume at a position between 6 oclock and 9 oclock, and leave it at this setting. Always use the AVA1210 volume control as a master main volume control. It has better electronics, higher signal to noise ratio and is more linear than any source unit volume control available. If engine noise is audible, check the ground connection on all units and in the audio system.
Features
- Volume control with up to 8 volts RMS of output
- Seven band equalizer with 18 dB boost/Cut
- Specific bandwidth for each band
- Low noise BI-FET op-amp design yields minimum distortion
- On-board 30 volt BI-Polar switching power supply
- Subwoofer outputs and level controls
- Subwoofer frequency selection switch (32Hz/64Hz/128Hz)
- Input selector for AUX or CD
- Universal half-DIN chassis for ease of installation
- Gold plated RCA input/output connectors
- 20 dB headroom eliminates signal overload
- Blue light illumination
Specifications
- Frequency bands: Front channel 125Hz, 500Hz, 3.5kHz, 12Khz / Rear channel 50Hz, 600Hz, 6.3kHz
- Boost/Cut: +/-18 dB
- Signal to noise ratio: 110 dB ref 1 volt input
- Frequency response: 1Hz 15kHz, +/-1 dB
- Maximum output voltage: 8 volts RMS
- Total harmonic distortion: 0.05%
- Input sensitivity: 150mV
- Headroom: 20 dB
- Input impedance: 10k Ohms
- Stereo separation: 82 dB/1kHz
- Operating voltage: 11-15 volts negative ground
- Output impedance: 50k Ohms
- Dimensions: 1 x 7 x 4-9/16 / 27.5mm x 178mm x 115mm
3. Powerbass Car Audio Eq Sound Processor 9-band Equalizer Pre-amp
Feature
Car Audio Sound Processor 9 Band Premium EqualizerFrequency Response: 20HZ-40KHz
2 Low Level RCA Inputs: Rear Aux and Rear CD
3 Low Level RCA Outputs: Sub, Front and Rear
Dimensions: 7" x 4" x 1"
Description
Technical Details: Car Audio Sound Processor 9 Band Premium Equalizer Model: XEQ-9XO Frequency Response: 20HZ-40KHz Variable Subwoofer Frequency Roll-off 30Hz-120Hz 2 Low Level RCA Inputs: Rear Aux and Rear CD 3 Low Level RCA Outputs: Sub, Front and Rear Pre Graphic Frequency: 50Hz, 120Hz, 250Hz, 500Hz, 1kHz, 2kHz, 4kHz, 8kHz and 16kHz Subwoofer frequency range: 30Hz-120Hz Channel seperation: 85dB Front Panel Source Selector Independent Subwoofer Volume Control Front and Rear Output Fader Dimensions: 7" x 4" x 1"4. Audiopipe EQ-709X 7 Band 9 Volt Universal Half DIN Graphic Car Audio Equalizer for Car Stereo Sound System Subwoofer Speakers (2 Pack)
Feature
Nickel-plated locking adjustable knobsAdjustable subwoofer frequency: 60Hz/90Hz
Universal half-DIN chassis for ease of installation
Active gain pre-amplifiers with adjustable input sensitivity
Individual left and right sensitivity controls for auxiliary input
Description
Every true audiophile should be able to tweak their sound system however they'd like to get the perfect sound. The Audiopipe EQ-709X 7-Band Parametric Graphic Equalizer can help get you there. The universal half-DIN-sized chassis gives you clean mounting options above or below most decks if you have room and the gold-plated RCA input connectors ensure that you always get the most signal. You'll even be able to control the volume of your subwoofer output independently with this EQ. Put yourself in the driver's seat of your music and system with the Audiopipe EQ-709X 7-Band Parametric Graphic Equalizer.5. Audiopipe EQ-709X 7-Band Graphic In-Dash Equalizer
Feature
CUSTOMIZED CONTROLS: Adjustable subwoofer frequency and subwoofer output level controls for customized useQUALITY PERFORMANCE: Nickel-plated locking adjustable knobs for user-friendly operation; Active gain pre-amplifiers with adjustable input sensitivity for maximum performance (Input sensitivity: 50mV-3V)
FREQUENCY RANGES: Graphic center frequencies: 50 Hz, 125 Hz, 315 Hz, 750 Hz, 2.2 kHz, 6 kHz, and 16 kHz; Subwoofer frequency: 60Hz/90H; Frequency response: 10 Hz-50 kHz, plus or minus 1 dB
SPECIALIZED CONTROLS: Individual left and right sensitivity controls for auxiliary input; Main/ auxiliary input selector; 20 dB headroom output and level controls; 3 stereo RCA outputs; Main/ auxiliary input selector
SPECIFICATIONS: Boost/cut: 18 dB; S/N ratio: 100 dB; Weight: 1.6 pounds; Manufacturer warranty: 1-year warranty; Maximum output voltage: 9 volts; THD: 0.005 percent;
6. Skar Audio SKA7EQ 7 Band 1/2 DIN Pre-Amp Car Audio Graphic Equalizer with Aux Input and High Voltage RCA Outputs
Feature
6 Channel 7-Band High Performance Car Audio 1/2 DIN Pre-Amp Electronic EqualizerFeaturing 2 (Balanced & Selectable) RCA Inputs - Main and Auxiliary (Aux w/ Variable Gain Control) | THD: 0. 005%
High Voltage (Max Output Voltage - 7V) Gold Plated Pre-Amp RCA Outputs - Front, Rear, and Subwoofer (with Variable Subwoofer Level Control on Front of EQ)
7 Fully Adjustable -12 dB to +12 dB EQ Bands (50 Hz, 125 Hz, 320 Hz, 750 Hz, 2. 2 kHz, 6 kHz, 16 kHz) with Built-in Fader Control
Take Full Control Over Your Car Audio System with this EQ | Signal-to-Noise Ratio: 100 dB, Low Pass Frequency Switch: 60 Hz / 120 Hz
Includes Installation Mounting Brackets and Hardware | 20 dB Headroom Eliminated Signal Overload
Included components: Installation Brackets and Hardware
7. Boss Audio Systems Bx45 2 3 Way Pre-amp Car Electronic Crossover - Variable High Pass Filter 40 Hz - 8 Khz Selectable Crossover Slopes, Selectable Phase Maximum Input Voltage 4.5 Volts, SILVER AND BLACK
Feature
CROSSOVER SLOPES: 3-way electronic is a high-fidelity signal processor that allows you to divide a stereo audio input signal into 3 separate channels. Subwoofer crossover is a low-pass filter designed to limit the subwoofer channel to low frequenciesVARIABLE BASS BOOST 0 12 DB: By connecting the BX45 to your amplifier, you will have total control of exactly how you want your bass to sound, as well as your mid-level and high-level frequencies, giving you the pristine listening experience
PARALLEL INPUT: If you set the subwoofer input mode selector switch to the ON position, front stereo input will be delivered to the crossover. You can create a very sophisticated 3-way audio system with only a pair of stereo input from your head unit
VARIABLE CROSSOVER: Variable Subwoofer Filter 32 Hz 250 Hz, Variable High Pass Filter 40 Hz 8 kHz. Has been designed and built to deliver excellent sound quality and long lasting high performance. Gives massive improvements to clarity/ distortion
DESIGNED TO IMPRESS: A thoughtful layout and clean design that gives you the user experience you've been wanting. Provides the perfect frequency distribution throughout your system to ensure the clarity and peak efficiency for your music arrangement
Media Type: Cd+Rw
8. Unstoppable
9. Audio Control Three.2 in-Dash Pre-Amp Equalizer/Subwoofer Crossover with Dual Auxiliary Inputs
Feature
In-Dash Pre-Amp Equalizer / Subwoofer crossover with Dual Auxiliary Inputs In-dash Pre-Amp Controller Two input channels and two, four, or six channels of outputStereo and Para-BASS equalization controls
On-board pre-amp line driver up to 13 volts peak Master volume control and fader Selectable illumination - Cool Blue or Hot Red LED's! Compact DIN chassis
10. Soundstorm SSL EVO4000.1 4000W Monoblock Class D Car Audio Amplifier Amp with Low Level Inputs/RCA Pre-amp Outputs and Variable Low Pass Crossover
Feature
AMPLIFIER: This Soundstorm Laboratories (SSL) EVO4000.1 Class D monoblock amplifier is perfect for your car audio setupWATTAGE: 4000 watt x 1 channel @ 1 Ohm; 3000 watt x 1 channel @ 2 Ohm; 150 watt x 1 channel @ 4 Ohm RMS Power
INCLUDES: Class D is a high speed switching amplifier technology that is more efficient, generates less heat and draws less power than traditional Class A/B amps
SPECIFICATIONS: Built-in Crossover Filter; Strapping Capability; and Remote Bass Knob Included
DIMENSIONS: 15" x 10" x 2.3"
